System Components

The WMS Wideband O2 System comes with the following:

	WMS Wideband controller / display. This all-in-one unit is small (2.4" x 1.5" x .8") and is easily mounted on the dash. It weighs less than 3oz and has a large, easy-to-read four-digit readout. Click here to look at the display comparison on the home page.
	Bosch LSU 4.2 sensor. Bosch technical information states the useful service life of the Bosch sensor itself is 100,000 miles or 10 years. Note: leaded fuel is not recommended with any O2 sensor and it will severely shorten the life of the O2 sensor. With lead content of .6 g/l drops sensor life to 15,000 miles. See technical information page for more information on the Bosch LSU 4.2 O2 sensor.
	Main wiring harness from controller to sensor. Large black plug for Bosch O2 sensor. The small end plugs into the back of the control box. Power and ground wires feed into the car's main wiring harness.
	RPM wiring harness. White wire used to simulate narrow band O2 sensor. Purple is for 0-5 volt output signal to SDS unit (if applicable; see below). Orange wire for RPM signal to control box. Green wire for external dataloggers. Click here for more information on the WMS SDS electronic fuel injection system.
	Datalogging cable plugs into side of control box with one end and into a laptop with the other.

System Features

• Works with EFI and carbureted applications.
• Excellent tool for monitoring AFR on engine and chassis dynamometers.
• Very easy installation - the main harness plugs into the controller / display and the sensor with only a power and ground wire to connect to function.
• Large LED display is easy to read when dash mounted and provides excellent real time monitoring of AFR. This allows easy monitoring without connecting the datalogging.
• Logs RPM as well as AFR, can accept RPM  signal from most tachometer signals, ignition boxes, stock coil packs or coil-on-plug ignition systems. RPM input can be calibrated with our software.
• All digital circuitry and surface mount technology for the most compact all in one controller / display on the market. Size is 2.4" x 1.7".
• Weight is under 3oz.
• Uses the 2-wire calibration resistor built into the sensors by Bosch, this is a much more accurate method of calibration than the free air method that other systems use.
• Accuracy to 1% , which is the inherent accuracy of the sensor itself.
• Datalogging software and cable is included with system. This allows datalogging and analysis of the data on a laptop with virtually unlimited amounts of data that can be stored.
• 0-5 volt output works with most aftermarket fuel injection systems or dataloggers
• 0-1 volt signal for OEM computers, emulates the stock narrowband O2 sensor. This allows you to remove the stock O2 sensor and replace with the wideband sensor.

Downloads

• installation manual [pdf | 526KB]
• software manual [pdf | 411KB]
• operating software (standard version) [exe | 2.97MB]
• operating software (without installer) [zip | 2.0 MB]

Important Message!

We no longer sell the WMS Wideband O2 system as there are too many low cost off shore systems on the market. We do still sell some service parts to repair or build a wideband system as well as a variety of other wideband O2 systems.

Click here for Wideband O2 parts we sell